Smeg HBE64CAS manual Conversions Cleaning, Changing the Type of Power Supply, Hotplate

CONVERSIONS

CLEANING

Disconnect the appliance from the mains supply prior to any conversions being carried out.

7)CHANGING THE TYPE OF POWER SUPPLY

Although they leave our factory preset for single- phase connection, certain appliances may by converted to the threephase system.

Comply with the following instructions:

a)Remove the hotplate from the top of the cabinet, overturn it, unscrew screw "Z" and remove under part (see fig. 9).

b)Shift connecting plate on terminal according to the following chart. This chart is also affixed to the hob.

c)Insert a supply cable of adequate section (see chart par. 10) through core hitch on the terminal board.

d)Connect the phase and earth wires to the relative terminal board.

e)Fix the supply cable in place using clamp.

f)Refit the hotplate, complying with the above instructions in reverse.

IMPORTANT:

Always disconnect the appliance from the electricity main before carrying out any cleaning operation.

3) HOTPLATE

If you want to preserve the surface clean and bright, periodically wash the hot plate with lukewarm soapy water.

Following this, all parts should be thoroughly rinsed and dried. Never wash them while they are still warm and never use abrasive powders.

Do not allow vinegar, coffee, milk, salted water, lemon or tomato juice from remaining in contact with the enamelled surfaces for long periods of time.

WARNINGS:

-Correctly preserve the plate after use by treating it with special products, easily available on the market. This will keep the surface of the plate clean and bright. The operation will also prevent the formation of rust.

-Any liquid overflowed the pans, must be always remove with a rag.

FIG. 9 FIG. 10

8 5