Loading the laundry, Open the machine lid | Smeg S800TL1 instruction

Loading the laundry

1.Open the machine lid.

2.Open the drum by pressing the button and keep your second hand on the big drum door at the same time.

3.Place the items of laundry in the drum one by one without compressing them. Follow loads recommended in the “Programme chart”: Overloading will result in unsatisfactory washing results and creased laundry.

4.To close the drum, please hold both doors in the middle again.

Attention: Make sure that the drum door flaps are properly locked, so that the button protrudes out beyond the edge of the big door flap.

1

2

3

GB 6

Image 6

Smeg S800TL1 manual Loading the laundry, Open the machine lid

Contents

Contents Remove the packaging and check Electrical connection Before Using the Washing MachineInstall the washing machine Remove the transport bracket Precautions and General Recommendations First Wash Cycle Description of the Washing Machine Preparation of the WashingSort the laundry Stain removal Dyeing and bleachingStarching Loading the laundry Open the machine lid Filling up with detergents and additives Detergents and AdditivesDosage Choice of the right detergents and additives Programme Selection Cleaning the Foreign Body Trap Draining Residual Water Detergent dispenser Check and clean regularly at least two or three times a year Water inlet hose filter Washing machine does not start, but the pilot lamp is on Water inlet hosesWashing machine does not start, no lamp lights up Washing machine stops during the programme Water stop fault depending on model Water Stop fault may have been triggered by Before contacting After-Sales Service Specify Removal of transport bracket Adjust the feet Connect the water inlet hose Water stop anti-flooding system Connect the water drain hose Fuse replacement Valid Only For Great Britain And IrelandPolarized Plugs e.g pin, 13 amp plug conforming to BS 1363A GB S 800 TL1 Freddo Cold Rapid button Rinse Hold buttonAppliance in Rinse Hold Half Load button