Important Safety Instruction
2. GENERAL INSTALLATION INSTRUCTIONS
•Proper installation is your responsibility. Have a qualified technician install this oven. Make sure you have everything necessary for proper installation. It is the responsibility of the installer to comply with installation information specified on the model/serial ID plate. The model/serial ID plate can be found on the internal frame of the oven when the door is opened.
•Have your oven installed and properly grounded by a qualified installer, in accordance with these installation instructions. Grounding is mandatory according to the provisions of electrical safety codes. If this appliance is connected to an external electrical power supply, it must be grounded in compliance with local codes, or, if no local codes exist, in compliance with the national ANSI / NFPA 70 code of electrical regulations.
•Make sure that the voltage and frequency of the power supply line correspond to the information indicated on the model/serial ID plate. A
•Do not attempt to repair or replace any part of your oven unless it is specifically recommended in this manual. All other service procedures should be performed by a qualified technician.
•This oven is not suitable for installation and operation in mobile homes or recreational vehicles.
•Electrical grounding is required. See the “Electrical Requirements” section. It is the customer’s responsibility:
-To contact a qualified electrical installer,
-To make sure that the electrical system is adequate and in compliance with the national ANSI / NFPA 70 ELECTRICAL CODE – latest edition – or the CANADIAN ELECTRICAL CODE, C22.11 – 1982 and C22.2 No. 01982 – or latest edition – and all local codes and ordinances. IMPORTANT: Observe all governing codes and ordinances.
5
