Smeg TKL9890 7. CLEANING AND MAINTENANCE

7. CLEANING AND MAINTENANCE

Important – Before cleaning or servicing the machine, remove the plug from the socket.

• Regular and constant cleaning will keep your appliance looking like new.

• Clean the outer surfaces with soap and water and then dry thoroughly with a soft cloth.

• Clean parts in plastic with a damp cloth.

• Do not scratch with sharp objects and do not use solvents or abrasive products as these will damage the

surface.

• For reasons of safety, never spray water onto the appliance.

• Remove any rust stains from the drum with a special cleaner for stainless steel or, for particularly

stubborn stains, with extra fine abrasive paper.

• To remove scale from the washer dryer, only use branded scale removers with anti-corrosion agents for

washing machines.

• Follow the manufacturer's instructions and recommended quantities to the letter.

• After removing scale or rust from the drum, perform a few rinse cycles to eliminate acid residues

as these may damage the machine. Never use detergents containing solvents. These may form

vapours that may catch fire and explode.

Periodically check that no clips, buttons, nails or needles have got caught in the folds of the door gasket.

Only clean the drain pump if it is obstructed by buttons, hairpins and the like and the water cannot drain.

In this case, proceed as follows.

1. Remove the plug from the socket to disconnect the machine from the electrical power supply.

2. Depending on the model, proceed as follows:

MODEL A – Use a coin to turn the plastic buttons

fixing the cover to the base plate anti-clockwise.

MODEL B – Insert a small screwdriver into the

slots in the base plate cover, then gently prise up

to release the upper part of the cover.

Pull the cover slightly forwards and then up to

remove it completely.