Snapper 3500W Portable Generator

ASSEMBLY

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at

1-800-317-7833. If calling for assistance, please have the model, revision, and serial number from the data tag available.

Unpacking the Generator

1.Set the carton on a rigid flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install wheel kit.

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use. You will need the following tools to install these components:

2 - 1/2" or 13mm wrench

15/16" wrench

Pliers

Install the wheel kit as follows (Figure 1):

1.Place bottom of generator cradle on a flat surface.

2.Tip generator so that engine end is up.

3.Place axle stud through wheel retainer on cradle frame.

4.Use 15/16” wrench to secure axle stud to frame with 5/8-18 jam nut.

Carton Contents

Check all contents against those listed below:

Main unit

Engine oil

Operator’s manual

Engine operator’s manual

Wheel kit

If any parts are missing or damaged, call the generator helpline at 1-800-317-7833.

5.Install other axle stud in same manner.

6.Install wheels on axle studs. Place flat washer over axle studs.

NOTE: Be sure to install wheels with raised hub inboard.

7.Retain wheels on axle studs with retaining pins.

8.Tip generator so that engine side is down.

9.Attach support leg using two 1/2” or 13mm wrenches with M8 x 20 mm capscrews and M8 lock nuts.

Figure 1 — Install Wheel Kit

Capscrew

 

 

Handle

 

 

Nut

Jam Nut

 

 

 

Washer

 

Axle

 

 

Stud

 

 

Capscrew

 

Mounting Leg

Wheel

Retaining Pin

 

 

 

 

Nut

 

 

6

 

Page 6
Image 6
Snapper 3500 manual Assembly, Unpacking the Generator, Install Wheel Kit, Carton Contents