#6-3041 SNAPPERIZER KIT for
SNAPPER 21" STEEL DECK MOWERS
This kit will install on all 21” Steel Deck:
RECOMMENDED USE: Install the Snapperizer for Spring and Fall
PREPARING THE MOWER FOR SNAPPERIZER
WARNING
Before attempting any adjustments, maintenance, service, or repairs, stop engine and blade, always remove key from ignition switch, remove spark plug wire and secure wire away from spark plug.
1.Disconnect the spark plug wire and secure it away from the plug to prevent unintentional starting.
2.Empty the fuel tank or tape vent in fuel filler cap closed to prevent leakage.
3.Tilt the mower back on its handles and block deck in raised position to allow working on the underside of the deck.
WARNING
Wear heavy leather gloves when handling or working around cutting blades. Blades are extremely sharp and can cause severe injury. Never use a cutting blade that shows signs of excessive wear or damage.
4.Block cutting blade to prevent it's turning then remove the blade. Save blade and hardware; these items will be reinstalled after the screen is in position.
5.Use a metal scraper and wire brush to remove dirt and grass clippings from the underside of the deck to allow proper fitting of the Snapperizer screen.
INSTRUCTION
INSTALLING THE SNAPPERIZER
1.Position the screen on underside and turn it until the three studs on the screen go through the matching holes in deck then secure with three split lockwashers and hex nuts on topside of deck. See Figure 1.
UNDERSIDE VIEW OF DECK
DISCHARGE
OPENING
FRONT OF
MOWER
Figure 1 - Screen Mounting Holes
2.Reinstall the cutting blade, position widest part of cone washer next to the blade then reinstall the retaining screw and tighten to 30 to 40 ft. lbs. torque. See Figure 2.
HUB (UNDER
BLADE)
CONE WASHER
TIGHTEN SCREW
TO 30 TO 40 FOOT
POUNDS
Figure 2 - Blade Installed After Screen
(over)
1