LUBRICATION CHECK / LUBRICATE FREE-HAND LINKAGE
Check the function of the
If the controls do not function properly, lubricate them. If lubrication does not rectify the problem, see your dealer. Under no circumstances should the unit be used if the controls are not functioning properly.
IMPORTANT NOTE
Storage
Figure 17. Lubricate Free Hand Control
It is very important that grease fittings on the auger shaft are lubricated regularly. If auger rusts to shaft, damage to worm gear may occur if shear pins do not break.
LUBRICATING THE AUGER SHAFT & ASSEMBLY
1.Remove cotter pin (C, Figure 18) and shear pin (B).
2.Use a grease gun and squirt several shots of grease into grease fitting (A).
3.Rotate auger assembly (D) several times to distribute the grease evenly. Repeat step 2.
4.Reinstall shear pin (B) and cotter pin (C).
5.Repeat procedure for other side.
STORAGE
WARNING
Never store the unit (with fuel) in an enclosed, poorly ventilated structure. Fuel vapors can travel to an ignition source (such as a furnace, water heater, etc.) and cause an explosion.
Fuel vapor is also toxic to humans and animals.
C |
B |
A |
B |
C |
A |
D |
D |
Figure 18. Checking Auger Gear Case Lubrication
A. | Grease Fittings | C. Cotter Pins |
B. | Shear Pins | D. Auger Assembly |
Before you store your unit for the
•Disengage the PTO, set the parking brake, and remove the key.
•Perform engine maintenance and storage measures listed in the engine owner’s manual. This includes draining the fuel system, or adding stabilizer to the fuel (do not store a fueled unit in an enclosed struc- ture - see warning).
Before starting the unit after it has been stored:
•Check all fluid levels. Check all maintenance items.
•Perform all recommended checks and procedures found in the engine owner’s manual.
•Allow the engine to warm up for several minutes before use.
19
