Section 3 - MAINTENANCE
3.1INTRODUCTION
To retain the quality of the mower, use genuine SNAPPER replacement parts only. Contact a local SNAPPER dealer for parts and service assistance. For the correct part or information for a particular mower, always mention model and serial number.
Refer to section “SERVICE SCHEDULE” in this manual and in the engine manual for correct maintenance intervals
WARNING
DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool. Wear heavy leather gloves when handling or working around cutting blades. Blades are extremely sharp and can cause severe injury.
3.2 SERVICE - AFTER FIRST 5 HOURS
The oil can be drained from the Kawasaki engine using one of the following methods. Dispose of all drain oil properly. Fill engine to proper level. Do Not over fill. Refer to Engine Owner’s Manual for oil specifications.
3.2.1.SIDE DRAIN PLUG. An oil drain plug is located on the left rear side of the engine. See Figure 3.1. Before removing the plug, place an open funnel or trough under the plug to keep oil off of the deck and to channel the oil to a drain pan. Torque drain plug to
Oil drain plug
FIGURE 3.1
IMPORTANT: Drain fuel tank before tipping machine. DO NOT tip machine with carburetor or spark plug down.
Oil from crankcase will saturate the air filter and cause the engine to be hard to start or not start at all. If contamination does occur, the air filter will have to be replaced.
3.2.2.BOTTOM DRAIN PLUG. An oil drain plug is located on the bottom of the engine forward of the crankshaft. See Figure 3.2. Gain access to the plug by raising the front of the mower. Remove plug and drain oil into pan. Torque drain plug to
3.2.3OIL DIPSTICK TUBE. The oil may be drained through the oil dipstick tube. Remove grass bag. Loosen lower handle knobs. Raise front of mower and stand mower up on the lower handle brackets. Remove dipstick and allow oil to drain into pan. See Figure 3.3.
Oil drain plug
FIGURE 3.2
REMOVE
DIPSTICK AND
DRAIN OIL
INTO PAN
FIGURE 3.3
9
