Snapper E9265, E11305 important safety instructions Repair & Adjustments

Section 4 - REPAIR & ADJUSTMENTS

WARNING

Before attempting any adjustments, maintenance, service, or repairs, stop engine and auger/impeller, always remove key from ignition switch, remove spark plug wire and secure wire away from spark plug. Before tilting machine, drain all the fuel from fuel tank. Allow engine to run, outdoors where fumes can be safely dissipated, until all fuel is removed from carburetor.

4.1.2. AUGER BELT ADJUSTMENT (IDLER PULLEY ADJUSTMENT) (Continued From Previous Page)

4.Recheck cable for proper extension.

5.Reinstall belt cover.

4.1.3.AUGER DRIVE BELT REPLACEMENT Inspect belt frequently for signs of excessive wear. Visually check engine drive belt for cracking, fraying, severed or belt strands exposed. NOTE: Auger and Drive Belts are difficult to install. It may be necessary to allow an authorized Snapper Dealer to install these belts.

1. Remove belt cover. See Figure 4.2.

2. Remove discharge chute.

3. Unhook both idler springs.

4. Loosen auger/impeller belt guide. See Figure 4.4.

IMPORTANT: Wheel drive belt will have to be removed from around engine drive pulley and engine shaft to install auger drive belt.

5.Remove auger drive belt from around engine pulley. See Figure 4.4.

WHEEL DRIVE BELT

BELT GUIDE	AUGER DRIVE
	BELT

UNHOOK

IDLER

SPRING

6.Tilt machine forward to gain access to drive system area. Secure machine in the tilted position to prevent tipping over. Remove drive system cover plate. See Figure 4.5.

SELF-TAPPING

SCREWS

REMOVE

COVER

FIGURE 4.5

7.Remove auger drive belt from drive disc pulley. Route auger belt through drive system in between rubber drive tire and drive disc.

8.Route new auger drive belt through drive system. NOTE: New belt has to be routed in between rubber drive tire and drive disc to position it around auger pulley.

9.Reinstall wheel drive belt onto engine wheel drive pulley. Make sure belt is also positioned in the drive disc pulley groove.

10.Route auger drive belt around engine auger drive pulley. Make sure belt is also positioned in the drive disc pulley groove.

11.Position belt guide against auger drive belt and tighten securely.

12.Reinstall both idler springs.

13.Reinstall discharge chute, belt and drive system covers and tighten screws securely.

14.Reinstall drive system cover plate.

15.See Sections 4.1.1. & 4.1.2. Auger Belt Adjustment for new belt adjustment. Adjust belt as described in these sections.

UNHOOK IDLER

SPRING

FIGURE 4.4

16