Snapper E9266, E11306 Annually END of Each Season, Engine Spark Plug, Storage Procedure

Section 3 - MAINTENANCE

3.4 ANNUALLY (END OF EACH SEASON)

Perform all maintenance as described in the maintenance schedule.

3.4.1. Engine

Refer to engine owner’s manual for service instructions.

3.4.2. Spark Plug

Refer to engine owner’s manual for service instructions.

3.5 STORAGE PROCEDURE

Refer to the Engine Owner’s Manual for directions regarding engine storage preparations. Prepare the snow thrower for “end of season” storage as follows:

1.Drain fuel from fuel tank and let engine run until all fuel is out of the carburetor.

2.Disconnect and remove the spark plug wire away from spark plug before any other preparations are made!

3.Tape all openings closed to prevent spraying water into exhaust or air intakes during washing.

4.Tilt snow thrower up on its wheels and thoroughly clean the underside of the auger/impeller.

5.Lubricate all exposed metal with a light coating of oil to prevent corrosion.

6.Store the machine in a shed or other dry area, protected from weather.

3.6MAINTENANCE and SERVICE PARTS

MAINTENANCE and SERVICE PARTS

Auger Drive Belt (Briggs Engines)	1-3937
Auger Drive Belt (Tecumseh Engines)	1-3939
Wheel Drive Belt (Briggs Engines)	1-3936
Wheel Drive Belt (Tecumseh Engines)	2-9101
Scraper Blade (24” Width Auger)	3-6122
Scraper Blade (26” Width Auger)	3-9770
Scraper Blade (30” Width Auger)	3-6006
Rubber Drive Tire	1-0765
Shear Bolts - 5/16-18 x 1-7/8”	9-1550
Hex Nuts - 5/16-18	9-1298
Parts Manual for Large Frame Snow Throwers - Series 6	#06069
Models: 8245, 8265, E8265, 9265, E9265, E9266, 10305,
E10305, 10305E, E10305E, E11305, E11306, N10305E

14