5maintenance (cont.)

ADJUSTMENTS:

!

BEFORE MAKING ANY ADJUSTMENTS, STOP ENGINE AND DISCONNECT SPARK PLUG

WIRE TO PREVENT INADVERTENT STARTING OF UNIT.

THROTTLE CABLE ADJUSTMENT: Correct cable adjustment allows for full range of movement of throttle body on engine in conjunction with throttle control on handle. To adjust, loosen cable clip screw on engine, then slide cable housing in or out in approximately 1/8- 1/4” increments. Retighten screw, recheck, and read- just as needed.

FRONT WHEEL CAMBER ADJUSTMENT: Correct camber adjustment will place the front axle at 0 degrees, or parallel with level ground, and the wheel at 90 degrees or perpendicular with level ground. Adjust by loosening the three mounting bolts and placing a square aside the wheel and adjusting until square sits flat on ground and touches upper and lower points of tire, then retightening bolts. An alternate method is to place a level against the side of the caster bracket.

LOOSEN SCREW

MOVE CABLE

0O

90O

REPLACEMENT PARTS:

Replacement parts are available through your dealer.

11

Page 11
Image 11
Snapper ELBX10152BV manual Adjustments, Replacement Parts