Snapper EP2167517BV important safety instructions Installation of Grass Catcher

Section 2 - OPERATING INSTRUCTIONS

WARNING

DO NOT attempt any maintenance, adjustments or service with engine and blade running. STOP engine and blade. Disconnect spark plug wire and secure away from spark plug. Engine and components are HOT. Avoid serious burns, allow sufficient time for all components to cool.

2.6RECYCLING OPERATION (Optional accessory on some models)

NOTE: For best recycling results, cut up to a maximum of 1/3 of grass blade length and recycle ONLY when grass is dry.

1.Set all wheels in the highest cutting position (Notch 6).

2.Move engine speed control to “FAST” (Rabbit) position.

3.Move ground speed control to slowest speed setting.

4.Proceed mowing slowly. If grass is very dense, lower each rear wheel latch one notch lower than the front wheel latches to improve recycling performance.

2.7INSTALLATION of GRASS CATCHER

Install grass catcher by sliding connector over flange of adapter. Attach grass bag hooks over middle handle cross bar. See Figure 2.9.

WARNING

DO NOT operate without entire Grass Catcher or guard in place. Grass Catcher components are subject to deterioration during normal use. Inspect frequently and replace worn or damaged components immediately.

2.8INSTALLATION of DISCHARGE DEFLECTOR (Optional accessory on some models)

1.Remove grass bag from handle and grass bag adapter. See Figure 2.10.

2.Remove front and rear nuts attaching grass bag adapter to deck. See Figure 2.10.

3.Install discharge deflector and secure to deck using hardware removed in Step 2. Slot in front edge of discharge deflector must be under nut as shown and both bolts protruding through holes in the side of the deflector. See Figure 2.11.

REMOVE GRASS BAG

FROM HANDLE AND

BAG ADAPTER

REMOVE NUTS

FIGURE 2.10

FRONT EDGE OF
DEFLECTOR UNDER
	NUT
NUT

FIGURE 2.9

FIGURE 2.11

8