Section 2 – OPERATING INSTRUCTIONS
2.1PRE-START CHECK LIST
Read, understand and follow instructions and warnings in this manual and on the machine, engine and attachments before operating. Know the controls and the proper use of the machine before starting. Make the following checks and perform the service required before each
2.1.1.Check guards, deflectors and covers to make sure all are in place and securely tightened.
2.1.2.Carefully inspect machine for loose, missing, damaged or worn components. Repair or replace as necessary before operating the machine.
2.1.3.Carefully inspect the debris bag and bag adapter for wear and deterioration. IMPORTANT – open top of bag to inspect interior of bag and the discharge deflector end of the bag adapter. Replace bag and bag adapter if they display signs of deterioration. The debris bag must be attached to the bag adapter, the bag adapter mounted onto the machine, and the zippered top fully closed before starting engine. The top rear corners of the bag are attached to the handles by using the cloth straps located near the top of the bag. See Figures 2.2 and 2.3.
2.1.4.Check engine oil and add oil as needed to bring level up to the FULL mark. Refer to engine owner’s manual for oil specifications. See Figure 2.1.
SAFE LEVEL
AREA
FIGURE 2.1
2.1.5.Check engine speed control to insure it works freely.
2.1.6.Clean exterior surfaces of machine and engine of any accumulation of dirt, grass, oil, etc. Keep engine air intake screen and cooling fins clear at all times.
2.1.7.Add fuel to tank after pushing the machine outside where fumes can dissipate. Make sure fuel filler cap is tight after refueling. Refer to engine owner’s manual for fuel specifications.
2.1.8.Adjust height of vacuum inlet. Lift up on handles. Squeeze height control lever against handle. Raise or lower handles until desired inlet height has been obtained. Release control lever. See Figure 2.4.
BAG ADAPTER
MOUNTED.
BAG
ATTACHED TO
HANDLES. TOP
ZIPPER FULLY
FIGURE 2.2
DEBRIS BAG
AND BAG
ADAPTER
MOUNTED TO
DISCHARGE
OPENING
FIGURE 2.3
HEIGHT
CONTROL
LEVER
FIGURE 2.4
8
