
Section 4 - ADJUSTMENTS & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. Stop engine. Stop blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns; allow all parts to cool before working on machine. Fuel Filler Cap and Vent must be closed securely to prevent fuel spillage.
4.3.9.MOWER DECK TIMING ROD
The mower deck timing rod is
4.3.10. WHEEL BRAKE ADJUSTMENT
Adjust the wheel brake if wheels turn when parking brake is engaged. Adjust the wheel brake by turning wheel brake adjusting nut clockwise to increase braking action or counter clockwise to decrease braking action. See Figure 4.11.
ADJUST | UNDERSIDE VIEW OF MACHINE |
COUNTER- |
|
CLOCKWISE TO |
|
DECREASE |
|
BRAKE |
|
ADJUST |
|
CLOCKWISE |
|
TO INCREASE |
|
BRAKE |
|
ELECTRIC
CLUTCH
WHEEL BRAKE
ROD
FIGURE 4.11
4.4 MOWER BLADE REPLACEMENT 4.4.1. BLADE WEAR LIMITS
1.Inspect blade frequently for signs of excessive wear or damage. See Figure 4.12.
4.4.2. BLADE SHARPENING
1.Make sure fuel cap is on tight. Turn fuel shut off valve (If equipped) to the “CLOSED” position. Start engine and allow it to run until engine runs out of fuel. Close vent on fuel filler cap. Refer Figure 2.3.
2.Remove key from ignition switch.
3.Remove spark plug wire(s) and secure away from spark plug(s).
4.Carefully stand YARD CRUISER on rear bumper.
5.Remove blade(s). See Figure 4.14.
6.Inspect condition of blade. See Figure 4.12.
7.Check blade balance after sharpening. If necessary, correct blade balance by grinding the heavy end of blade.
NEW BLADE
WEAR LIMIT (NOTCH STARTS)
DANGEROUS CONDITION!
DO NOT USE ON MOWER!
REPLACE WITH NEW BLADE.
FIGURE 4.12
8.If blade is in good condition, sharpen at 22 to 28 degrees. DO NOT sharpen beyond existing cutting edge. See Figure 4.13.
DO NOT SHARPEN |
|
BEYOND ORIGINAL |
|
CUTTING EDGE | 22º TO 28º |
|
BLADE TIP
ORIGINAL CUTTING EDGE
FIGURE 4.13
9.Reinstall blade. See Figure 4.14. Torque blade mounting bolts to recommended range of:
33” Deck - 30 to 40 ft. lbs.
REINSTALL MOUNTING
BOLTS TO SECURE
BLADE
FIGURE 4.14
20