Snapper Intermediate Frame Snow Throwers SPRING SHOULD STRETCH 3/8” WHEN HANDLE IS DEPRESSED

STEP 8: ADJUSTMENT: Adjust cable lengths so that each spring stretches 3/8” when the clutch lever is depressed. When released, both clutch cables should be slack. See Figure 8.

SPRING SHOULD STRETCH 3/8”

WHEN HANDLE IS DEPRESSED

CONNECTOR

JAM

NUT

TO ADJUST, LOOSEN JAM NUT AND TURN CONNECTOR TO SHORTEN OR LENGTHEN CABLE AS NEEDED TO ATTAIN THE 3/8” EXTENSION. TIGHTEN JAM NUT AFTER ADJUSTING.

FIGURE 8

STEP 9: LUBRICATION: Remove check plug to check grease level in auger gear case. If grease is not visible from check plug hole, pump BENELENE 900 grease, SNAPPER Part No. 2-9577, into fill plug on case until grease is visible. Reinstall check plug. See Figure 9.

GEAR CASE

GREASE FITTING

CHECK PLUG

FIGURE 9

STEP 10: CHECKLIST: Complete all items on the Pre- Operation Checklist as instructed.

3