DEALER SET-UP INSTRUCTIONS for EUROPEAN SNAPPER
21” STEEL DECK “M” MODEL WALK BEHIND MOWERS
This SNAPPER Walk Behind Mower uses a handle engine control bail system to kill the engine for the SAFETY of the operator. These mowers are designed for quick
PUSH MODELS
STEP 1: Remove mower from shipping carton. Mower shown as removed from shipping carton with handles folded in Figure 1.
MOWER SHOWN AS REMOVED FROM SHIPPING
CARTON WITH HANDLES FOLDED (PUSH
MODEL SHOWN)
FIGURE 1
STEP 2: Remove and discard cardboard from between all handles. Raise upper handle until it is in line and seats into lower handle. Securely tighten upper handle
| UPPER | LOWER |
| |
UPPER | HANDLE | LOWER | ||
HANDLE | ||||
HANDLE | ||||
| HANDLE | |||
|
|
|
LOWER
HANDLE
BRACKET
STEP 3: Raise upper and lower handle until it seats into position in the lower handle brackets. Securely tighten lower handle
UPPER HANDLE &
LOWER HANDLE
SHOWN IN POSITION
LOWER
HANDLE
FIGURE 3
IMPORTANT: DO NOT tip machine with carburetor or spark plug down. Oil from crankcase will saturate the air filter and cause the engine to be hard to start or not start at all. If contamination does occur, the air filter will have to be replaced.
IMPORTANT: DO NOT tip machine with carburetor or spark plug down. Oil from crankcase will saturate the air filter and cause the engine to be hard to start or not start at all. If contamination does occur, the air filter will have to be replaced.
STEP 4: Tip mower back against the upper handle to gain access to cutting blade. Remove foam shipping block from cutting blade. This must be removed before starting the engine.
FIGURE 2
INSTRUCTION No.