Section 2 - OPERATING INSTRUCTIONS
2.4HANDLE HEIGHT ADJUSTMENT
The height of the mower handle can be adjusted as follows:
1. Loosen the lower nuts on each lower handle as shown in Figure 2.8.
HIGHER
LOWER
HANDLE
LOWER
LOOSEN LOWER
NUTS ON EACH
LOWER HANDLE
2.5CUTTING HEIGHT ADJUSTMENT
2. Set all wheels at the same cutting height. The highest cutting position is Notch 6. The lowest cutting position is Notch 1. See Figure 2.10.
LATCH
POSITION
CUTTING HEIGHT SETTINGS
FIGURE 2.10
FIGURE 2.8
2.Move upper mower handle up or down until the desired position is achieved.
3.Tighten the lower nuts on each lower handle to maintain desired position.
WARNING
Stop engine and mower blade by releasing the blade control before adjusting cutting height.
2.5CUTTING HEIGHT ADJUSTMENT
1. Pull the height adjusting latch outward and move to desired cutting height. See Figure 2.9.
1
LOWEST CUTTING | LATCH |
HEIGHT |
1
2
3
4
5
6
HIGHEST CUTTING HEIGHT
6
FIGURE 2.9
8
