Snapper RP215517HC, RP217017BVE, MRP215517B Operating Instructions, Pre-Start Check List

Section 2 - OPERATING INSTRUCTIONS

2.1PRE-START CHECK LIST

Make the following checks and perform the service required before each start-up.

2.1.1.Check guards, deflectors, grass bag, adapter and covers to make sure all are in place and securely tightened.

2.1.2.Check blade control and wheel drive control to insure they work freely. See Figure 2.1.

BLADE

CONTROL

2.2STARTING & OPERATION 2.2.1. ENGINE & BLADE (Primer Models)

1. Move engine speed control to the “Fast” (Rabbit) position. See Figure 2.3.

IMPORTANT: Certain models do not have a separate engine speed control. These models have a fixed non-adjustable engine speed. Proceed to step 2 and prime engine to start.

NOTE: Stop the engine (and blade) by releasing the blade control.

WHEEL

DRIVE CONTROL

ROPE START HANDLE

BLADE CONTROL

FIGURE 2.1	ENGINE SPEED
	CONTROL

2.1.3.Check cutting height. Adjust to desired height.

2.1.4.Check engine oil and add oil as needed to bring level up to the full mark. Refer to Engine Owner’s Manual for oil specifications. See Figure 2.2.

IGNITION

KEY

ENGINE SPEED CONTROL (SHOWN IN FAST POSITION)

FIGURE 2.3

2.Push primer button three times to start a cold engine. NOTE: The primer should not be required to restart a warm engine. See Figure 2.4

3.Pull blade control against handle.

4.Pull rope start handle to crank engine.

5.After engine starts, allow a brief warm-up until engine runs smooth.

FIGURE 2.2

2.1.5.Add fuel to tank after pushing the mower outside where fumes can safely dissipate. Make sure cap is tightened after refueling. Refer to Engine Owners Manual for specifications.

2.1.6.Clean exterior surfaces of cutting deck and engine of any accumulation of spilled fuel, dirt, grass, oil, etc. Keep engine air intake screen and cooling fins clear at all times.

PRIMER

FIGURE 2.4

6