Malfunctions - Causes and how to eliminate them
| Indicator | Remedy |
|
|
|
| An acoustic signal confirms |
|
| that entry was correct |
|
| Incorrect entries are indicated |
|
| by 5 acoustic signals in swift |
|
| sucession | Check that your entry is |
|
| |
|
| correct - if necessary interrupt |
|
| the command sequence by |
|
| pressing ”C” or ”CI”. |
|
|
|
| The scale sets the value zero | Remove the items from the |
| automatically when it is | weighing platform. Remove |
| switched on. If the scales are | any dirt. If the scales do not |
| outside the set tolerance | indicate zero after a couple of |
| range, | seconds, you should contact |
|
| your service partner. |
|
|
|
| Underloaded: only the | Switch the scales off and on |
| bottom horizontal lines | again. The zero point will be |
| appear on the display | reset automatically. |
|
|
|
| Overload: Only the top | Remove some of the items to |
| horizontal lines appear on | be weighing from the scales. |
| the display. The maximum |
|
| weighing range has been |
|
| exceeded. |
|
| Weight of item too light. |
|
| The zero setting range has |
|
| been exceeded |
|
| Taring is not possible in case |
|
| of over- or underloaded |
|
| balance |
|
| Printing is not possible in case |
|
| of over- or underloaded |
|
| balance. |
|
| kg / lb conversion is blocked |
|
| Totals memory occupied |
|
| - must be cleared before |
|
| commutation - |
|
|
| In case of all error indications: |
|
| Please contact your |
|
| service- partner. |
|
|
|
19