DRAINING THE COLLECTED WATER

When the drainage tank is full, “” in the LED display will turn on and the unit beeps to alert the user and operation will stop automatically. The water then needs to be emptied from the drainage tank.

Emptying the Drainage Tank

1. Lightly press on the sides of

2. Carefully discard the

the tank with both hands and

collected water.

pull out gently.

 

NOTE:

1.Do not remove the styrofoam packing from the float on the unit. The float on the unit will no longer be able to detect the water level correctly without the styrofoam packing, and water may leak from the water tank. This can cause electrical shock and/or short circuits.

2.If the drainage tank is dirty, wash it with cold or lukewarm water. Do not use detergent, scouring pads, chemically treated dust cloths, gasoline, benzene, thinner, or other solvents, as these can scratch and damage the tank and cause water leakage.

3.When replacing the drainage tank, press the tank firmly into place with both hands. If the tank is not positioned properly, the WATER FULL sensor will be activated, and the dehumidifier will not operate.

4.If the drainage tank is removed while the unit is in operation, or immediately after operation has stopped, water that is still in the cooling unit may drip out onto the base plate. Always wait at least 30 minutes before removing the drainage tank to avoid drips. (If water has dripped, wipe it up.)

5.Do not drink the water collected in the drainage tank.

Continuous Water Drainage

The unit features a continuous drainage port. By attaching the included 12-inch hose, the water in the drainage tank can be continuously drained out of the port on the unit. NOTE: When setting up the equipment for continuous drainage, always stop operation first and unplug the power supply plug.

1.Remove the plug from the drainage port on the back of the unit. Attach the included hose and run to a gravity drain. You may need additional hose to run the water to a gravity drain. Check the hose periodically to make sure it is still connected and has not been obstructed.

2.The drain hose must always lie flat and maintain a downhill grade to make sure that collected water can be drained out with the force of gravity.

8