Soleus Air FS2-40R-32 manual Base Assembly, Fan Head Assembly

ASSEMBLY

WARNING: DO NOT plug in fan before assembly.

Tools required: Phillips screwdriver (not included)

Base Assembly:

1.Unscrew the two screws from the neck of the fan head. Slide the neck of the fan head over the pole of the stand, aligning the screw holes. Secure the pole by inserting and tightening the two screws.

2.Turn the stand upside down and place the base over the bottom of the stand. Align the pre-drilled holes on the bottom of the base with the stand. Use the 4 included screws to secure the stand to the base.

Fan Head Assembly:

Unscrew the mounting nut counter clockwise from the motor shaft.

Position the back grill over the motor shaft, fitting the holes in the back grill over the knobs that protrude from the front of the mo-

tor. Make sure the rear grill fits securely against the motor housing.

Secure the back grill by screwing on the mounting nut. Turn clockwise and tighten firmly.

Slide the fan blade onto the motor shaft with the fan blade’s shaft sleeve facing the motor. Make sure the groove in the shaft sleeve

fits over the spring bolt on the motor shaft.

Attach the fan blade by screwing the securing knob onto the motor shaft counter clockwise.

Position front grill so logo is horizontal. Attach the grills together by positioning the top tab of the front grill over the back grill. Firmly press the black ring of the front grill onto the back grill, snapping

into place. This completes the assembly.

4