www.sylvane.com
SAFETY INFORMATION
1.Use Copper wire only rated at least 60°C (140°F)
2.For supply connections use No.10 AWG or larger wires suitable for at least 60°C (140°F)
3.Heater air flow must be directed parallel to, or away from, adjacent walls.
4.Observe wall, floor, and ceiling clearance requirements on DIAGRAM 1 on Page 5 of this manual.
5.Do not install closer than 1 5/8” (41.27mm) from the ceiling, 6 feet (2.4 meters) from the floor, or 13” (330mm) from a wall
6.All wiring must comform to national and local electrical codes in the United States and the heater must be grounded as a precaution against possible electrical shock. Heater circuit must be protected with proper fuses.
7.Install only in an area where the proper
8.The mounting structure and the anchoring hardware must be capable of easily and reliably supporting the weight of the heater and the mounting bracket (if used).
9.All electrical power must be disconnected and the main service box must be locked before installing, inspection, cleaning, or servicing the heater to prevent the chance of electrical shock.
10.This heater is not suitable for use in hazardous locations as definied by the National Fire Protection Association (NFPA) in the United States. This heater has hot and arcing (sparking) parts inside. Do not use in ares where gasoline, paint, or flammable liquids are used or stored.
11.This heater is not suitable for use in corrosive atmospheres such as marine, greenhouses, or chemical storage areas.
12.Do not install less than 6 feet (2.4 meters) from of the floor.
Improper installation or failure to follow the instructions outlined in this product manual can result in electrical shock.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
NO USER-SERVICEABLE PARTS INSIDE
4
