ASSEMBLY
TOOLS NEEDED: Phillips Head Screwdriver
This heater requires assembly of the LEGS and WHEELS only. There are 3 ways to assemble the LEGS and WHEELS of the heater. The first way is to used both the LEGS and WHEELS. Assembling the heater in this manner will allow the heater to be rolled using the supplied wheels. The second assembly method uses the LEGS only, and the third method uses small RUBBER FEET (included) instead of the LEGS and WHEELS. Using the LEGS and WHEELS assembly, or LEGS only assembly will result in more stability and less chance of the heater possibly tipping over.
LEGS and WHEELS assembly
1.Attach the WHEELS to the LEGS using the supplied WHEEL SCREWS and WASHERS.
2.Place the WHEEL SCREW inside the wheel (see Figure A below). The screw head should be placed between the WHEELS. The threads of the screw will show through the top of the WHEEL.
3.Place the SMALL BLACK SPRING WASHER over the thread of the screw and on top of the wheel.
4.Place the SMALL GREY WASHER over the thread of the screw and on top of the SMALL BLACK WASHER.
5.Tighten the screw to attach the WHEEL to the LEG. Repeat this process for the other WHEELS and LEGS.
6.After assembling the WHEELS and LEGS is complete, simply place the LEGS over the 4 LEG MOUNTS on the bottom of the heater. Once the LEGS are snapped in, assembly is complete.
LEGS only assembly
1.Place the LEGS over the 4 LEG MOUNTS on the bottom of the heater. Once the LEGS are snapped in assembly is complete.
Rubber Stopper assembly
1.Place each of the 4 RUBBER FEET on the bottom of the 4 LEG MOUNTS.
2.Each RUBBER FOOT has a connector that must be placed inside the small hole on the bottom of the LEG MOUNTS.
3.Assembly is complete once the RUBBER FEET are firmly attached to the LEG MOUNTS.
FIGURE A
WHEEL SCREW 
WHEEL 
SMALL BLACK SPRING WASHER
LEG | SMALL GREY WASHER |
|
6
