d)Mount terminal ends of the exhaust hoses to the unit.
e)Open window or sliding door for approximately 5 inches (130 mm)
f)Adjust the length of the window kit to the same length of the window or the sliding door. Use all three panels if necessary. Cut the window piece as needed to fit the length of your window or sliding door. Make sure that both holes on the main piece are not covered by other pieces.
g)Place the window kit to the window or sliding door. Close the window or door as far as it goes.
h)Adjust the lengths of exhaust hose and affix the window kid adapters onto the holes on the window kit.
NOTE: When using the window kit on a window or sliding door it will cause the window or sliding door not to be properly closed and locked. Additional security measurements should be taken
Wall Mount
1)Do not use window kit adapter. Mount the one end of the exhaust ducts onto holes of 5” on the wall.
2)Using exhaust outlet wall covers to cover the holes in the wall when the unit is not in use.
NOTE: In order to increase the efficiency, the exhaust ducts should be keeping as short and straight as possible. It is not recommended to increase the manufacturer’s length of the exhaust hose. This may impede or damage the unit.
CONTROL PANEL AND VFD DISPLAY
CONTROL PANEL
6