OPERATION
Plug the power cord into a properly grounded outlet. Do not connect the unit to an outlet that is also being used for other electrical appliances. The unit will beep after two seconds, then press the on/off button to begin operation.
COOLING
1.Press the Mode Button to choose the cooling function.
2.Press the Fan Speed Button to choose the desired fan speed.
3.Press the Swing Button to select a steady airflow or oscillation.
•In order to improve cooling efficiency, draw the curtains in a room exposed to direct sunlight.
•Do not place near a heat source.
DEHUMIDIFYING
1.Press the Mode Button to choose the dehumidifying function.
•In the Dehumidifying Mode, the fan speed cannot be adjusted.
•Ensure that the water bucket is properly placed in the unit.
•When the unit is used as a dehumidifier only, do not use the exhaust duct.
•Keep the windows and doors closed to aid in effectively dehumidifying the room.
FAN
1.Press the Mode Button to choose the fan function.
2.Press the Fan Speed Button to choose the desired fan speed.
3.Press the Swing Button to select a steady airflow or oscillation.
EMPTYING THE WATER BUCKET
When the unit is in cooling mode, unwanted water is extracted from the air. When the water bucket is full, the compressor will stop but the fan will continue to run.
To resume operation, empty the water bucket according to the following steps:
1.Turn the unit off. Do not move the unit when the water container is full.
2.Using the handle, slowly remove the water bucket from the unit.
3.Pour out any water accumulated in the bucket.
4.Wash the water bucket using warm water and a mild dishwasher detergent.
5.Allow the bucket to dry completely
6.Replace the water bucket in the unit.
9