English / USA
STOP
0
6
4 
5 | KN | |
146BA006 | ||
|
When engine begins to fire:
:Press in decompression valve.
:Move Master Control lever (4) to n and continue cranking – as soon as engine runs, immediately blip the throttle trigger (5) –
the Master Control lever (4) will move to the “Run” position # (6) and the engine will settle down to
150BA007 KN
:Pull the hand guard back toward the front handle:=
The chain brake is now disengaged
– your saw is ready for operation.
Always disengage chain brake before accelerating engine. High revs with the chain brake engaged (chain locked) will quickly damage the powerhead and chain drive (clutch, chain brake).
At very low outside temperatures:
:Allow engine to warm up at part throttle.
:Change over to winter operation if necessary – see “Winter Operation”.
To shut down the engine:
:Move Master Control lever to $
If fuel tank has been run until dry and then refueled:
:Press in decompression valve.
:Start as described for warm engine (warm start n).
If fuel tank has been run completely dry (engine stops) and then refueled:
:Press in button to open the decompression valve.
Start as described for cold engine (cold start l).
.
idling speed.
As the chain brake is still engaged,
the engine must be returned to idling speed immediately – or the engine and chain brake might otherwise be damaged.
:Observe safety precautions.
:Always check operation of chain lubrication before starting work.
MS 270, MS 270 C, MS 280, MS 280 C | 41 |