Replacing a Broken Rewind Spring
:Remove the rope rotor.
The bits of spring might still be under tension and could fly apart when you take them out of the fan cover. To reduce risk of injury, wear eye and face protection and work gloves.
:Use a screwdriver to carefully remove the parts of the spring.
:Lubricate the new spring with a few drops of
001BA103 KN
:Place the replacement spring with frame in the fan cover – the spring loop must engage the lug in the fan cover.
:Apply a suitable tool (screwdriver, punch or similar) to the recesses (arrows) and push the spring into its seat in the fan cover – the spring slips out of the frame in this process.
:Reinstall the rope rotor, tension the rewind spring, fit the fan cover and secure in position with the screws.
English / USA
Storing the Machine
For periods of about 3 months or longer:
:Drain and clean the fuel tank in a well ventilated area.
:Dispose of remaining fuel and cleaning solution properly in accordance with local environmental requirements.
:Run engine until carburetor is dry, this helps prevent the carburetor diaphragms sticking together.
:Remove the saw chain and guide bar, clean them and spray with corrosion inhibiting oil.
:Thoroughly clean the unit,
pay special attention to the cylinder fins and air filter.
:If you use a biological chain and bar lubricant, e.g. STIHL BioPlus, completely fill the chain oil tank.
:Store the unit in a dry and high or locked location, out of the reach of children and other unauthorized persons.
MS 270, MS 270 C, MS 280, MS 280 C | 51 |