Sony 26-483-01 Sony RS-232Projector Configuration, Sony LCD Compatible Installation, Model, Cable

Sony LCD Compatible Installation Configuration and Connections

Sony RS-232 Projector Configuration

Verify that the System 8/10 PLUS is already configured for a Sony RS-232 projector. The general setup is explained on page 3-4 and the switch settings for the projector are repeated below.

1. Use a small screwdriver to remove the access cover from the System 8/10 PLUS front panel. See bottom of page 3-3. The label on the back of the access cover also has the configuration information.

__________ Before changing anything, remove the AC power cord to the System 8/10 PLUS

to verify that the main power is OFF; also turn the projector power OFF.

2. Set the switches as follows:

Config

Model

Rotary Switches

Cable

SW15 Settings

Comm

as

RS1

RS2

RS3

RS4

J2/J3

1

2

3

4

5

6

7

8

9

10

Adapter

Sony RS-232

0

0

E

8

J2

↓

↓

↑

↓

↑

↓

↓

↓

↑

↓

26-473-01

ON

1 2 3 4 5 6 7 8 9 10

_RS5 is for RGB switching delay. See page 3-4 for more information on switch functions.

RS2

RS5 RS2 RS1

RS1

SW15 DIP Switch

RS3 RS4

RS3

RS4

Configured For:

RS-232

3. Use a grease pencil (or other rub-off marker) to mark the space on the label next to “Sony RS-232”.

4. Locate the switcher’s Address DIP switches on the rear panel, lower right. Unless this is part of a master/slave system, set #3 and #5 to the up position and the others down. See illustration to the left.

Use the illustration on the next page to do the following steps.

5.Connect the Comm Adapter to the “RS-232C/RS-422A” port. Connect the CC- 50' (or CC-100') cable from the 9-pin male connector of the Comm Adapter to the 15-pin HD “Projector Control” port located on the rear panel of the System 8/ 10 PLUS. Set the projector’s RS-232C/RS-422A switch to the RS-232C position.

______ Secure the screws on all D connectors.

6.Connect the BNC (RGBS) cables from the System 8/10 PLUS outputs to “INPUT A” of the projector. For S-Video or Composite Video input, use the “VIDEO IN” projector connectors.

7.Apply Main Power to the System 8/10 PLUS by connecting the power cord. The

Main Power LED should light. Apply power to the projector.

8. Return System 8/10 PLUS and projector to normal operation.

Extron • System 8/10 PLUS • User’s Manual • P/N 68-428-01 Rev. E Page 6