Sony 4-131-978-11(1) Step 1: Connecting the Aerial Cable, 1, 2

16
Step 1: Connecting the Aerial Cable
Connect the aerial cable by following the steps below.
“Standby Mode” is set to “Mode 1” (default) in the “System 1” setup and the picture does not
appear on the TV when the recorder is in standby mode.
To watch TV in standby mode, set “Standby Mode” to “Mode 2” in “Step 6: Ea sy Setup”
(page2 3) or use a splitter to divide aerial input signals between the TV an d the recorder.
z
You can also set “Standby Mode” to “Mode 2” in the “System 1” setup (page 87).
b
• If your aerial is a flat cable (300-ohm twin lead cable), use an exte rnal aerial connector (not supplied) to
connect the aerial to the recorder.
• If you have separate cables for AERIAL antennas, use an AERI AL UHF/VHF band mixer (not supplied)
to connect the aerial to the recorder.
1Disconnect the aerial cable from your TV, and connect it to AERIAL IN on the rear
panel of the recorder.
2Connect AERIAL OUT of the recorder to the aerial input of your TV using the supplied
aerial cable.
DVD recorder
TV
to aerial input
to AERIAL OUT
to AERIAL IN
Aerial cable (supplied)
: Signal flow
Wall