Recording
To | Press or slide |
Stop playback/stop fast | p6 |
forward or rewind* |
|
Tape speed is faster than the normal playback speed.
nThe TAPE SPEED switch is set between the 1.2 cm and 2.4 cm positions.
Operating Instructions
Manual de instrucciones (en el reverso)
M-417/427/427AD/427C/ 437/529V/539V
EAR |
| |
| Microphone | |
| REC/BATT | |
TAPE | r | |
CPAUSE | ||
SPEED | 0CUE/REVIEW ) | |
TAPE | ||
p6 | ||
COUNTER | ||
|
Pause playback | Slide CPAUSE in the direction of |
| the arrow. The BATT lamp goes off. |
|
|
Fast forward | Slide 0CUE/)REVIEW toward |
| 0CUE during stop** |
|
|
Rewind | Slide 0CUE/)REVIEW toward |
| )REVIEW during stop.** |
|
|
Search forward during | Keep 0CUE/)REVIEW pushed |
playback (CUE) | down during playback and release it |
| at the point you want.** |
Recording cannot be made.
nConnection is made incorrectly.
nThe batteries are weak. Replace both batteries with new ones.
nThe head is contaminated.
nImproper setting of the VOR switch
Recording is interrupted.
nThe VOR switch
Recording cannot be erased completely.
Sony Corporation © 1997 Printed in China
For the customers in the USA
Owner’s Record
The model number is located at the bottom and the serial number is located inside the battery compartment. Record these numbers in the spaces provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product.
Model No. |
| Serial No. |
|
WARNING
To prevent fire or shock hazard, do not expose the unit to rain or moisture.
VOR |
m | m |
p6 |
|
Search backward during | Keep 0CUE/)REVIEW pushed |
playback (REVIEW) | up during playback and release it at |
| the point you want.** |
|
|
*If you leave the unit after the tape has been wound or rewound, the batteries will be consumed rapidly. Be sure to depress p6.
**The tape moves faster in the rewind/REVIEW mode than in the fast forward/CUE mode.
Note
If the tape is completely rewound while searching backward during playback (REVIEW), the 0CUE/)REVIEW switch may not return to the center position when you release the switch. In this case, push back the switch to the center to start playback.
At the end of the tape
In the recording or playback mode, the tape stops at the end of the tape and the locked buttons will be released automatically (Automatic
After fast forward or rewind, be sure to return 0CUE/ )REVIEW to the center.
nThe head is contaminated.
Maintenance
2
3
1
Welcome!
Thank you for purchasing the Sony Microcassette- Corder. Some features are:
•The BATT lamp indicates when to replace the batteries. •The VOR (Voice Operated Recording) system
response to the sound.
•Edit
•Tape counter
•Automatic
About This Manual
The instructions in this manual are for the
Preparing Power Sources
Choose one of the following power sources.
Dry Batteries
| ] |
} | } |
] |
|
Make sure that nothing is connected to the DC IN 3V jack.
1Open the battery compartment lid.
2Insert two R6 (size AA) batteries with correct polarity and close the lid.
If the battery compartment lid is accidentally detached
Attach it as illustrated.
When to replace the batteries
Replace the batteries with new ones when the BATT (battery) lamp dims and the sound is distorted.
Battery life (Approx. hours)
Batteries | Recording |
Sony R6P (SR) | 5.5 |
|
|
Sony alkaline LR6 (SG) | 19 |
|
|
House Current
to the wall outlet
DC IN 3V
AC power adaptor (supplied with
Connect the AC power adaptor to DC IN 3V and to a wall outlet. Use the AC power adaptor (supplied with
Polarity of the plug
1
TAPE COUNTER.
2Press p6and insert a standard microcassette with the side to start recording facing the lid.
3Select the desired tape speed.
2.4cm for optimum sound (recommended for normal use): A
1.2cm for longer recording time: A
4
If you set VOR to H or L, the unit automatically starts recording the sound and pauses when there is no sound (you can save tapes and batteries).
H: To record at meetings or in a quiet and/or spacious place.
L: To record for dictation or in a noisy place.
When the sound is not loud enough, set it to OFF, or the unit may not start recording.
5Press r. Recording starts. Recording level is fixed.
To | Press or slide |
Stop recording | p6 |
|
|
Start recording during | rduring playback (the unit becomes |
playback | in the recording mode) |
|
|
Review the portion | Push up 0CUE/)REVIEW |
just recorded | toward )REVIEW during |
| recording. Release the button at the |
| point to start playback. |
|
|
Pause recording | Slide CPAUSE in the direction of |
| the arrow. The BATT lamp goes off. |
|
|
Take out a cassette | p6 |
|
|
Note
Select the 2.4 cm tape speed for recording, if you play back the recorded tape with another unit. Otherwise, the sound quality may be changed.
Notes on VOR (Voice Operated Recording) (M-529V/539V only)
•The VOR system depends on the environmental conditions. If you cannot get the desired results, set VOR to OFF.
•When you use the system in a noisy place, the unit will stay in the recording mode. If the sound is too soft, on the contrary, the unit will not start recording. Set VOR to H (high) or L (low) depending on the conditions.
To monitor the sound
Connect the earphone (not supplied) to the EAR jack. The monitor volume cannot be adjusted by VOL.
To prevent a cassette from being accidentally recorded over
Break out and remove the cassette tabs. To reuse the cassette for recording, cover the tab hole with adhesive tape.
Playing a Tape
1Insert a cassette with the side to start playing facing the lid.
2Select the tape speed to the same speed as that used for recording.
3Press 9.
4Adjust the volume.
EARVOL
| BATT | |
TAPE | CPAUSE | |
9 | ||
SPEED | ||
0CUE/REVIEW ) | ||
| ||
| p6 |
Recording/Playback with the Connected Equipment
Dubbing onto another tape recorder
Set this unit to the playback mode and another tape recorder to the recording mode.
EAR
MIC
Connecting cord RK-G64HG (not supplied)
Precautions
On power
•Operate the unit only on 3 V DC.
For AC operation, use the AC power adaptor recommended for the unit. Do not use any other type. For battery operation, use two R6 (size AA) batteries.
•The nameplate indicating operating voltage, etc., is located on the bottom of the unit.
On the unit
•Use only the y(standard microcassettes) with this unit.
Standard | Only standard | |
| microcassette have a |
|
| small indentation of |
|
| side A. |
|
| Approx. 5 mm | Approx. 2.5 mm |
•Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock.
•Should any solid object or liquid fall into the unit, remove the batteries or disconnect the AC power adaptor, and have the unit checked by qualified personnel before operating it any further.
•Keep personal credit cards using magnetic coding or
•When you do not use the unit for long, remove the batteries to avoid damage caused by battery leakage and subsequent corrosion.
•If the unit has not been used for long, set it in the playback mode and warm it up for a few minutes before inserting a tape.
If you have any questions or problems concerning your unit, please consult your nearest Sony dealer.
Troubleshooting
Should any problem persist after you have made these checks, consult your nearest Sony dealer.
A cassette cannot be inserted.
nThe cassette is being inserted in the wrong way. (The cassette should be inserted in the lid with the tape side facing you.)
n9has been already pressed.
rcannot be pressed.
nThere is no cassette in the cassette compartment.
nThe cassette tab has been removed.
ror 9 cannot be pressed. n The tape has reached the end.
n After the automatic
The unit does not operate.
nThe batteries have been inserted with incorrect polarity
nThe batteries are weak. Replace both batteries with new ones.
nCPAUSE is slid in the direction of the arrow.
nThe AC power adaptor or car battery cord is connected to the unit only and you are going to use the unit on batteries.
No sound comes from the speaker.
nThe earphone is plugged in.
nThe volume is turned down completely.
The sound drops out or comes with excessive noise.
nThe volume is turned down completely.
nThe batteries are weak. Replace both batteries with new ones.
nThe head is contaminated. See “Maintenance”.
Tape speed is too fast or too slow in the playback mode.
nImproper setting of the TAPE SPEED switch. Set it to the same speed as that used for recording.
To clean the tape head and path
Press 9and wipe the head 1, capstan 2 and the pinch roller 3 with a cotton swab, moistened with alcohol every 10 hours of use.
To clean the exterior
Use a soft cloth slightly moistened in water. Do not use alcohol, benzine or thinner.
Specifications
Tapey(normal position type)
Recording systemApprox. 3.6 cm (17⁄16 in.) dia.
Tape speed2.4 cm/s (15⁄16 ips), 1.2 cm/s (15⁄32 ips)
Frequency range300 – 4,000 Hz
OutputEarphone jack (minijack) for 8 – 300 ohms earphone Power output (at 10% harmonic distortion)
160 mW
Battery life (recording)See “Preparing Power Sources”.
Power requirements•Two R6 (size AA) batteries: 3 V DC
•Sony
120/220 V AC, 50/60 Hz (model for other countries) (for
120 V AC, 60 Hz
Approx. 66.7 x 120.8 x 25 mm incl. projecting parts and controls
MassApprox. 160 g incl. batteries
Supplied accessoriesMicrocassette tape
Microcassette tapes
AC power adaptor (1)
Sony batteries LR6 (SG) (2)
Design and specifications are subject to change without notice.
Optional accessories
Microcassette
Connecting cord