20GB
Getting Started
Step 2: Connecting the System
For connecting the system, read the information on the following p ages.
Do not connect the AC power cord (mains lead) of the unit to a wall outlet (mains) until all the other
connections are made.
Note
•When you connect another compon ent with a volume control, turn down the volume of the other compon ents to a
level where sound is not distorted.
To remove the panel cover of the unit
Before connecting the cables, remove the panel cover from the unit.
Note
•Before using the unit, re move the seal attached at the lower rear of the unit.
The connector of the speaker cords and the color tube are color-cod ed depending on the type of speaker.
Connect the speaker cords to match the color of the SPEAKERS jacks of the unit.
Be sure to match the speaker cords to the appropriate terminals on the speakers: the speaker cord with
the color tube to 3, and the speaker cord without the color tube to #. Do not catch the speaker cord
insulation (rubber covering) in the speaker terminals.
Connecting the speakers
Hold the panel cover at (A), then slide it out to
the side.
A