Location and Function of Parts

Front

1 2 3

APower switch

Turns on/off the power of this unit.Turn on the power of the BRC-H700 camera before you turn on this unit.

BPower indicator

Lit in green: This unit is in normal operation.

Lit in red: The power of the camera connected to this unit is turned off. Turn it on.

Flashing in red: Abnormal operation of this unit. Display the composite video signal on the monitor and check the error message. Check also the connection.

CDATA MIX switch

Set the switch to ON to overlap the menu with the video signal output from the installed interface board. Set it to OFF not to overlap the menu.

Rear

4

 

5 6

 

 

AUDIO OUT

 

 

 

L

 

 

 

R

 

 

 

FUNCTION ~AC IN

 

 

1

6

 

 

VISCA RS-422

 

CAMERA IN EXT SYNC OUT

RGB/COMPONENT

IN VISCA RS-232C OUT

 

7 8 9

0

qa qs qd

qf

DCard slot

Insert an optional interface board, HFBK-SD1, HFBK-HD1, HFBK-XG1 or HFBK-TS1.

The slot cover is attached to the unit at the factory.

EAUDIO OUT L/R jacks

Loop through output of the audio line signal input from the AUDIO IN jacks on the BRBK-H700 HD

Optical Multiplex Card inserted into the camera via the Optical Fiber Cable.

F~AC IN connector

Connect the supplied AC power cord.

GCAMERA connector

Connect to the optical connector of the BRBK- H700 HD Optical Multiplex Card installed in the BRC-H700 camera using the CCFC-M100HG Optical Fiber Cable.

A dustproof cap is attached at the factory.

HEXT SYNC IN connector Accepts external video sync signals.

IEXT SYNC OUT connector

Supplies external video sync signals input from the EXT SYNC IN connector.

J RGB/COMPONENT connector

Supplies the images from the camera as YPbPr or RGB signal.

KVISCA RS-232C IN connector

Connect to the RM-BR300 Remote Control Unit (not supplied). When you connect multiple cameras, connect it to the VISCA RS-232C OUT connector of the previous camera in the daisy chain connection.

LVISCA RS-232C OUT connector

When you connect multiple cameras, connect it to the VISCA RS-232C IN connector of the next camera in the daisy chain connection.

MVISCA RS-422 connector

Connect to the VISCA RS-422 connector of the camera or another BRU-H700 HD Optical Multiplex Unit.

For the connection to the VISCA RS-422 connector, see “Using the VISCA RS-422 Connector Plug” on page 10.

NVISCA FUNCTION switches

These switches are used for the VISCA communication settings.

Switch 1 (RS-232C/RS-422 selector)

Set to ON for RS-422, or OFF for RS-232C.

Switch 2 (Communication baud rate selector)

Set to ON for 38400bps, or OFF for 9600bps.

Location and Function of Parts 5 GB