Sony CDP-CX57 Loading the Disc Memos of the second CD player, Labeling discs of the second CD player

Playing CDs

1Press MEGA CONTROL on this player.

The MEGA CONTROL button and “2nd” in the display light up. The display shows the current disc number or disc memo of the second player.

ALL DISCS		4
	CD1	4
	CD1

2nd DISC

* D I S C - 4 *

Current disc number or the Disc Memo

2Press PLAY MODE to select the play mode you want.

To program tracks, use the controls on the second player.

You cannot change the second CD player’s ALL DISCS Play mode to 1 DISC Play mode, and vice versa, by using the PLAY MODE button on this player.

3Press ·on this player to start playing.

The play starts and the display shows the current disc and track numbers and the playing time of the track.

While the MEGA CONTROL button is lit, you can control the second player with the controls on this player.

To control the second player directly using the supplied remote

Set CD 1/2/3 on the remote to CD 3 which is the same position as the COMMAND MODE selector on the rear panel of the second player.

To control this player again

Press MEGA CONTROL. The MEGA CONTROL button goes off and you can control this player.

Loading the Disc Memos of the second CD player

If the second CD player has the Disc Memo function (see page 24), you can load the Disc Memos of the second CD player to this player’s memory and display them on this player.

1Press INPUT.

2Turn the JOG dial until “LOAD 2ND MEMO” appears in the display.

ALL DISCS

CD1

L O A D 2 N D M E M O

3Push the JOG dial.

This player starts loading. (Loading takes about one minute.)

Note

If each Disc Memo of the second CD player has more than 13 characters, the first 13 characters of each are loaded to this player.

Labeling discs of the second CD player

You can label discs of the second CD player or change the Disc Memos loaded from the second CD player.

1Press MEGA CONTROL.

The MEGA CONTROL button lights up.

2Turn the JOG dial to select the disc you want to assign a Disc Memo to, then push the JOG dial. If the disc slot you select does not have any disc, “NO DISC” appears in the display and you cannot assign a Disc Memo.

3Press INPUT.

“DISC MEMO” appears.

4Push the JOG dial.

5Input the new Disc Memo following the procedure in “Labeling Discs” on pages 24 to 26.

Note

The new Disc Memos are stored on this player’s memory, so you cannot display them on the second CD player.