Other Functions

Adjusting the sound characteristics

You can adjust bass, treble, balance and fader. Each source can store the bass and treble level independently.

1 Select the Y-em you want to adjust by pressing (SEL) repeatedly.

VOL (volume) nBAS (bass) nTRE (treble) nBALANCE (left-right) nFADER (front-rear)

2 Adjust the selected item by pressing (+)

EN

or (–).

Adjust within three seconds after selecting

 

 

the item. (After three seconds, the buttons

 

work as volume control buttons.)

Attenuating the sound

Press (ATT). “ATT” flashes.

To restore the previous volume level, press (ATT) again.

Changing the sound and beep tone

Enjoying bass and treble even at low volume — Loudness

Bass and treble will be reinforced.

Press (2) while pressing (SEL). “LOUD” appears in the display.

To cancel, press these buttons again.

Attenuating the beep tone
Press (6) while pressing (SEL).

To obtain the beep tone again, press these buttons again.

Note

If you connect an optional power amplifier and do not use the built-in amplifier, the beep tone will be disabled.

Turning on the clock

display — Power Select Function

Only for cars with an accessory position on the ignition key switch

To turn the Power Select Function ON

Press (OFF) while pressing (SEL). The Power Select Function ties the clock display power to the accessory position on the ignition key switch.

To avoid battery wear, the clock is not displayed while the unit is initializing.

8