3-241-107-21(1)

FM/MW/LW

Compact Disc

Player

Installation/Connections
安裝／線路連接

CDX-CA900

Sony Corporation © 2002 Printed in Thailand

2

A

AUDIO OUT

 

FRONT

 

SUB OUT (MONO)

AUDIO OUT

REAR

B

BUS AUDIO IN

 

BUS CONTROL IN

BUS AUDIO IN

Source selector*

音源選擇器*

XA-C30

BUS CONTROL IN

* not supplied

 

非附送

1

1

2

3

4

⋅ 4

567

⋅2

8

9

q;

⊕ Κ3 ⋅ 12

Equipment used in illustrations (not supplied)插圖中的裝置（非附送）

Front speaker

Power amplifier

前揚聲器

功率放大器

Rear speaker

CD/MD changer

後揚聲器

CD/MD 換碟機

Active subwoofer

Rotary commander RM-X4S

有源超低音揚聲器

旋轉式控制器 RM-X4S

Cautions
•This unit is designed for negative earth 12 V DC operation only.

•Do not get the wires under a screw, or caught in moving parts (e.g. seat railing).

•Before making connections, turn the car ignition off to avoid short circuits.

•Connect the yellow and red power input leads only after all other leads have been connected.

•Run all earth wires to a common earthpoint.

•Be sure to insulate any loose unconnected wires with electrical tape for safety.

Notes on the power supply cord (yellow)

•When connecting this unit in combination with other stereo components, the connected car circuit’s rating must be higher than the sum of each component’s fuse.

•When no car circuits are rated high enough, connect the unit directly to the battery.

Parts Iist (1)
The numbers in the list are keyed to those in the instructions.CautionHandle the bracket 1 carefully to avoid injuring your fingers.
Connection example (2)

Notes (2-A)

•Be sure to connect the earth cord before connecting the amplifier.

•If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated.

Tip (2-B- )

For connecting two or more CD/MD changers, the source selector XA-C30 (optional) is necessary.

Connection diagram (3)

1To a metal surface of the car

First connect the black earth lead, then connect the yellow and red power input leads.

2To the power aerial control lead or power supply lead of aerial booster amplifier Notes

•It is not necessary to connect this lead if there is no power aerial or aerial booster, or with a manually-operated telescopic aerial.

•When your car has a built-in FM/MW/LW aerial in the rear/side glass, see “Notes on the control and power supply leads.”

3To AMP REMOTE IN of an optional power amplifier

This connection is only for amplifiers. Connecting any other system may damage the unit.

4To the interface cable of a car telephone

5To a car’s illumination signal

Be sure to connect the black ground lead to it first.

6To the +12 V power terminal which is energized in the accessory position of the ignition key switch

Notes

•If there is no accessory position, connect to the +12 V power (battery) terminal which is energised at all times.

Be sure to connect the black earth lead to it first.

•When your car has a built-in FM/MW/LW aerial in the rear/side glass, see “Notes on the control and power supply leads.”

7To the +12 V power terminal which is energised at all times

Be sure to connect the black earth lead to it first.