2 Rotate the volume control dial to adjust the selected item.
After 3 seconds, the setting is complete and the display returns to normal play/reception mode.
With the card remote commander
In step 2, to adjust the selected item, press <, M, , or m.
Customizing the equalizer curve
— EQ3
“Custom” of EQ3 allows you to make your own equalizer settings.
1 Select a source, then press (EQ3) repeatedly to select “Custom.”
2 Press the select button repeatedly until “LOW Center Frequency” appears.
3 Rotate the volume control dial to select the desired frequency.
LOW Frequency can be set to 60 Hz or 100 Hz.
4 Push the select button.
5 Rotate the volume control dial to adjust the volume level.
The volume level is adjustable in 1 dB steps, from –10 dB to +10 dB.

Other functions

Changing the sound settings

Adjusting the sound characteristics

You can adjust the balance, fader, and subwoofer volume.

1Press the select button repeatedly until “Balance,” “Fader” or “Sub Woofer” appears.

The item changes as follows:

equalizer setting*1 t Balance (left-right) t Fader (rear-front) t

Sub Woofer (subwoofer volume)*2 t

AUX Level*3

*1 When EQ3 is activated (page 9).

*2 “– ∞” is displayed at the lowest setting, and can be adjusted up to 20 steps.

*3 When AUX source is activated (page 11).

6Push the select button.

Repeat steps 3 to 6 to adjust “MID” and “HIGH.”

MID and HIGH frequencies differ but are set in the same way (MID: 500 Hz or 1.0 kHz; HIGH: 10.0 kHz or 12.5 kHz).

To restore the factory-set equalizer curve, press and hold the select button before the setting is complete.

After 3 seconds, the setting is complete and the display returns to normal play/reception mode.

Tip

Other equalizer types are also adjustable.

With the card remote commander

In step 3 and 5, to adjust the selected item, press <, M, , or m.

Adjusting setup items — SET

1Press and hold the select button.

The setup display appears.

2Press the select button repeatedly until the desired item appears.

3Rotate the volume control dial to select the setting (example “on” or “off”).

4Press and hold the select button.

The setup is complete and the display returns to normal play/reception mode.

Note

Displayed items will differ, depending on the source and setting.

With the card remote commander

In step 3, to select the setting, press < or ,.

continue to next page t

9