Getting Started
Resetting the unit
Before operating the unit for the first time, or after replacing the car battery or changing the connections, you must reset the unit.
Detach the front panel and press the RESET button with a pointed object, such as a
RESET button
Note
Pressing the RESET button will erase the clock setting and some stored contents. Custom memory of HDEQ, DSO 3D and Intelligent Time Alignment
Setting the clock
The clock uses a
1Press (MENU).
2Rotate the SEEK control dial until “SETUP” appears, then press
(ENTER).
3Rotate the SEEK control dial until “Clock Adjust” appears, then press
(ENTER).
The clock adjustment display appears.
4Rotate the SEEK control dial to set the hour and minute.
To move the digital indication, press
(ENTER).
5After setting the minute, press
(ENTER).
The clock starts.
With the card remote commander
In steps 2 to 4: press M or m instead of the SEEK
control dial; in step 4: press < or , instead of (ENTER).
Detaching the front panel
You can detach the front panel of this unit to prevent theft.
Caution alarmIf you turn the ignition switch to the OFF position without detaching the front panel, the caution alarm will sound for a few seconds. The alarm will only sound if the
1Press (OFF).
The unit is turned off.
2Press .
The left side of front panel is released.
3Slide the front panel to the left, then gently pull out the front panel towards you.
(OFF)
2
1
Notes
•Do not drop or put excessive pressure on the front panel and display window.
•Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray.
4