3-237-525-11(1)

FM/AM

Compact Disc

Player

Installation/Connections
Installation/Connexions

CDX-L300

Sony Corporation © 2002 Printed in Korea

2

A

B

AUDIO OUT

1

1

2

 

3

 

 

 

⋅ 4

⋅ 2

 

 

 

 

 

4

5

 

6

Equipment used in illustrations (not supplied)Appareils utilisés dans les illustrations (non fournis)

Front speaker

Power amplifier

Haut-parleur frontal

Amplificateur de puissance

Rear speaker

Haut-parleur arrière

Parts Iist (1)
The numbers in the list are keyed to those in the instructions.CautionHandle the bracket 1 carefully to avoid injuring your fingers.
Cautions
•This unit is designed for negative ground 12 V DC operation only.

•Do not get the wires under a screw, or caught in moving parts (e.g. seat railing).

•Before making connections, turn the car ignition off to avoid short circuits.

•Connect the yellow and red power input leads only after all other leads have been connected.

•Run all ground wires to a common ground
point.

•Be sure to insulate any loose unconnected wires with electrical tape for safety.

•The use of optical instruments with this product will increase eye hazard.
Notes on the power supply cord (yellow)

•When connecting this unit in combination with other stereo components, the connected car circuit’s rating must be higher than the sum of each component’s fuse.

•When no car circuits are rated high enough, connect the unit directly to the battery.

Connection example (2)

Notes (2-B)

•Be sure to connect the ground cord before connecting the amplifier.

•If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated.

Connection diagram (3)

1To a metal surface of the car

First connect the black ground lead, then

connect the yellow and red power input leads.

2To the power antenna control lead or power supply lead of antenna booster amplifier Notes

•It is not necessary to connect this lead if there is no power antenna or antenna booster, or with a manually-operated telescopic antenna.

•When your car has a built-in FM/AM antenna in the rear/side glass, see “Notes on the control and power supply leads.”

3To AMP REMOTE IN of an optional power amplifier

This connection is only for amplifiers. Connecting any other system may damage

the unit.

4To the +12 V power terminal which is energized in the accessory position of the ignition key switch

Notes

•If there is no accessory position, connect to the +12 V power (battery) terminal which is energised at all times.

Be sure to connect the black ground to it first.

•When your car has a built-in FM/AM antenna in the rear/side glass, see “Notes on the control and power supply leads.”

5To the +12 V power terminal which is energised at all times

Be sure to connect the black ground to it first.

Notes on the control and power supply leads

•The power antenna control lead (blue) supplies +12 V DC when you turn on the tuner.

•When your car has built-in FM/AM antenna in the rear/side glass, connect the power antenna control lead (blue) or the accessory power input lead (red) to the power terminal of the existing antenna booster. For details, consult your dealer.

•A power antenna without relay box cannot be used with this unit.