Getting Started
Resetting the unit
Before operating the unit for the first time, or after replacing the car battery or changing the connections, you must reset the unit.
Detach the front panel and press the RESET button with a pointed object, such as a ballpoint pen.
RESET button
Note
Pressing the RESET button will erase the clock setting and some stored contents.
Setting the clock
The clock uses a
The setup display appears.
2Press (SEL) repeatedly until “CLOCK-ADJ” appears.3Press (DSPL).The hour indication flashes.
4Press the volume +/– button to set the hour and minute.To move the digital indication, press (DSPL).
5Press (SEL).The clock starts and the next setup display appears.
6Press and hold (SEL).The setup is complete.
To display the clock, press (DSPL). Press (DSPL) again to return to the previous display.
With the card remote commander
In step 4, to set the hour and minute, press M or m.
DEMO mode
When the unit is turned off, the clock is displayed first, then demonstration (DEMO) mode starts the demonstration display.
To cancel the DEMO mode, set
Detaching the front panel
You can detach the front panel of this unit to prevent theft.
Caution alarm
If you turn the ignition switch to the OFF position without detaching the front panel, the caution alarm will sound for a few seconds. The alarm will only sound if the
The unit is turned off.
2Press , then pull it off towards you.(OFF)
Notes
•Do not drop or put excessive pressure on the front panel and display window.
•Do not subject the front panel to heat/high temperature or moisture. Avoid leaving it in a parked car or on a dashboard/rear tray.
Tip
When carrying the front panel, use the supplied front panel case.
Attaching the front panel
Engage part A of the front panel with part B of the unit, as illustrated, and push the left side into position until it clicks.
A
B
Note
Do not put anything on the inner surface of the front panel.
4