11 Connect the calibration mic to the A.CAL MIC jack on the front panel and press X/x to select [YES].

Set up the calibration mic at the ear level using a tripod, etc. (not supplied). The front of each speaker should face the calibration mic, and there should be no obstruction between the speakers and the calibration mic. Be quiet during the measurement.

AUDIO IN / MIC 1 /A.CAL MIC

Calibration mic

12 Press.

AUTO CALIBRATION

Connect calibration mic. Start measurement?

YES

NO

Auto Calibration starts.

Note

•Loud test sound is output when [AUTO CALIBRATION] starts. You cannot turn the volume down. Give consideration to children and neighbor.

•Avoid being in the measurement area and making noise during the measurement (which takes about 3 minutes), as it may interfere with measurement.

13 Unplug the calibration mic and press C/cto select [YES].

Measurement complete.

FRONT L :

YES

FRONT R :

YES

CENTER :

NONE

SUBWOOFER :

YES

SURROUND L :

NONE

SURROUND R :

NONE

If OK, unplug calibration mic and select

“YES”.

YES

NO

 

Note

•The environment of the room in which the system is installed may affect measurements.

•If measurement fails, follow the message then retry [AUTO CALIBRATION].

•When you select [SECOND ROOM] for [SPEAKER FORMATION], measurement of [SURROUND L] and [SURROUND R] is not displayed.

14 Press .Quick Setup is finished. All connections and setup operations are complete.To quit the Quick SetupPress DISPLAY in any Step.

Tip

•If you change the position of the speakers, reset the speaker settings. See “Getting Optimal Surround Sound for a Room” (page 65) and “Calibrating the Appropriate Settings Automatically” (page 67).

•If you want to change any of the settings, see “Using the Setup Display” (page 69).

continued

– BASIC – Started Getting

15GB