32 GB
Cannot save an
image.
• Did you save images from a
computer to the internal
memory without making a
folder in the internal
memory?
cIf you do not make a folder, you can only
save up to 512 images. In addition, the
number of images may be reduced
depending on the file name length or
character type. When you save images in
the internal memory from a computer, be
sure to make a folder in the internal
memory and save the images in this
folder.
Cannot delete an
image.
• Is the memory card write-
protected? Or is the write-
protect switch locked?
cUse the device you are using to cancel
write-protection and try deleting again.
cSlide the write-protect switch to the
enable position.
• Is this image protected? cCheck the image information from the
single view mode. (page 18)
cAn image with a mark is set to “Read
Only”. You cannot delete it on the photo
frame.
Nothing happens
even if you operate
the photo frame.
—
cTurn off the power then turn it on
(page13) .
cPush the RESET switch with a thin object,
such as a ballpoint pen. (page9)
PNote
If you push the RESET switch while the photo
frame is in operation, the data in its internal
memory may be erased or the settings may be
reset.
Nothing happens
even if you operate
the remote control.
• Is the battery inserted in the
remote control properly?
cReplace the battery. (Digital Photo Frame
Handbook, page 9)
cInsert a battery in the proper orientation.
(Digital Photo Frame Handbook, page 9)
—
cPoint the top end of the remote control
towards the remote sensor on the photo
frame.
cRemove any obstruction between the
remote control and the remote sensor.
• Is there a protective sheet
inserted?
cRemove the protective sheet. (page11)
• Is the AC adaptor connected
correctly?
cThe 1 (standby) button on the remote
control cannot be used when the photo
frame is powered only by the built-in
battery pack. Use the 1 (standby) button
on the photo frame.
Symptom Check item Cause/Solutions