Symptom | Cause and/or Solution |
Your personal computer | • The battery level is low. |
does not recognize your | t Use the AC power adaptor (page 14). |
camera. | • The camera is turned off. |
| |
| t Turn on the camera. |
| • The USB cable is not connected firmly. |
| t Disconnect the USB cable, and connect it again |
| firmly. Make sure that “USB MODE” is |
| displayed on the LCD screen (pages 33, 35). |
| • The USB connectors on your personal computer are |
| connected to other equipment besides the keyboard, |
| the mouse, and your camera. |
| t Disconnect the USB cables except for the ones |
| connected to the keyboard, the mouse, and your |
| camera. |
| • The USB driver is not installed. |
| t Install the USB driver (page 33). |
| • [USB CONNECT] is set to [PTP] in the setup settings. |
| t Set it to [NORMAL] (page 81). |
| • Since the camera is connected to a computer with |
| the USB cable before installing the USB driver, the |
| drive is not recognized by the computer. |
| t Delete the drive which is not recognized, then |
| install the USB driver. For details, see the |
| procedure on page 93. |
|
|
No function works though | t Remove the battery pack, then install it again |
the power is on. | after about one minute. If the function still do |
| not work, press the reset button located on the |
| bottom using a |
| press the reset button, the date and time setting |
| is cleared.) |
|
|
92