12Press X/x to select whether or not you wish to send a DTS signal to your amplifier (receiver).

Choose the item that matches the audio connection you selected on pages 22 to 24 ( B through D ).

B-2 C-2

• OFF (page 72)

D

•ON (only if the amplifier (receiver) has a DTS decoder) (page 72)

13Press ENTER.

Quick Setup is finished. All connections and setup operations are complete.

If your AV amplifier (receiver) has an MPEG audio decoder, set “MPEG” to “MPEG” (page 72).

Enjoying the surround sound effects

To enjoy the surround sound effects of this player or your amplifier (receiver), set the following items as described below for the audio connection you selected on pages 22 to 24 ( B through D ). Each of these is the default setting and does not need to be adjusted when you first connect the player. See page 66 for using the Setup Display.

Audio Connection (pages 22 to 24)

A

• No additional settings are needed.

B-1 C-1

•Set “DOWNMIX” to “DOLBY SURROUND” (page 71)

•If the sound distorts even when the volume is turned down, set “AUDIO ATT” to “ON” (page 71)

B-2 C-2 D

•Set “DOWNMIX” to “DOLBY SURROUND” (page 71)

•Set “DIGITAL OUT” to “ON” (page 71)

Attaching the Stand

You can use the player laid horizontally, or in an vertical position. Be sure to attach the supplied stand when using in the vertical position.

1 Fit the projection of the stand into the slot on the side of the player.

2 Slide the stand back and forth to align the screw holes.

Select two screw holes to decide the foot position.

3 Secure the two supplied screws.

4 Stand the player up.

Hookups

,continued 27