Notes

•You cannot enjoy a picture with an S video signal if your TV does not conform to the S video signal. When your TV does not have an S VIDEO input, connect the component via the VIDEO INPUT connector using the audio/video connecting cord (supplied) instead of the S video cord. For details, see page 8.

Refer to the instructions supplied with your TV.

•Refer to the instructions supplied with the component to be connected.

•You cannot make digital audio recordings of discs recorded in multi-channel surround format directly using an MD deck or DAT deck.

•When you connect the component via the DIGITAL OUT OPTICAL or COAXIAL connector, set Virtual Enhanced Surround (VES) to “OFF.” Otherwise, the player will not output signals from the DIGITAL OUT OPTICAL or COAXIAL connector, if you set “DOLBY DIGITAL” in “AUDIO SETUP” to “D-PCM.”

When you have made the connections using an optical or coaxial digital connecting cord, do not set “DOLBY DIGITAL” to “DOLBY DIGITAL” and “DTS” to “ON.” If you do, a loud noise will suddenly come out from the speakers, affecting your ears or causing the speakers to be damaged.

Setups for the player

Some setup adjustments are necessary for the player depending on the components to be connected.

Use the setup display to change the various settings. For details on using the setup display, see page 43.

•To listen to the sound through speakers connected to a receiver (amplifier) which has a digital connector and lacks a built-in DTS or Dolby Digital decoder, or to output the sound to a digital component such as a DAT or MD deck

Set the “AUDIO SETUP” items in the setup display (page 51) as shown in the illustration below. These are the default settings.

AUDIO SETUP

 

 

 

AUDIO ATT:

OFF

 

 

AUDIO DRC:

STANDARD

 

 

DOWNMIX:

DOLBY SURROUND

 

 

DIGITAL OUT:

ON

Set the

 

DOLBY DIGITAL:

D-PCM

 

items as

 

DTS:

OFF

 

shown

 

 

 

To set, press , then ENTER .

To quit, press DISPLAY .

Set “VES” to “OFF” in the Control Menu display (page 33). When you select any VES mode other than “OFF,” no sound will come from the speakers.

Note

When you output the signals which do not reproduce the Dolby Surround (Pro Logic) effect from the DIGITAL OUT OPTICAL or COAXIAL connector, set “DOWNMIX” to “NORMAL” in “AUDIO SETUP” in the setup display (page 52).

Started Getting

11