Setups for the player when using the
digital connecting cords
Connect the component via the DIGITAL OUT OPTICAL or COAXIAL connector using an optical or coaxial digital connecting cord (not supplied). You do not need to use the audio connecting cord.
Some setup adjustments are necessary for the player depending on the components to be connected.
Use the setup display to change the various settings. For details on using the setup display, see page 52.
If your receiver (amplifier) does not have a builtin Dolby* Digital decoder, MPEG decoder or DTS decoder
•To listen to the sound through speakers connected to a receiver (amplifier) which has a digital connector, or to output the sound to a digital component such as a DAT or MD deck
Set the “AUDIO SETUP” items in the setup display (page 63) as shown in the illustration below. These are the default settings.
AUDIO SETUP |
|
|
| |
| AUDIO ATT: |
| OFF |
|
| AUDIO DRC: |
| STANDARD |
|
| CENTER SPEAKER EQ: | FLAT |
| |
| DOWNMIX: | DOLBY SURROUND |
| |
| DIGITAL OUT: |
| ON | Set the items |
| DOLBY DIGITAL: |
| ||
| MPEG: |
| PCM | as shown |
| DTS: |
|
| |
| 48kHz/96kHz PCM: | 48kHz/16bit |
|
To set, press , then ENTER .
To quit, press DISPLAY .
When you have made the connections using an optical or coaxial digital connecting cord, do not set “DOLBY DIGITAL” to “DOLBY DIGITAL,” “MPEG” to “MPEG,” “DTS” to “DTS” and “48kHz/96kHz PCM” to “96kHz/24bit.” If you do, a loud noise will suddenly come out from the speakers, affecting your ears or causing the speakers to be damaged.
Note
You cannot make direct digital audio recordings of discs recorded in multichannel surround format using an MD deck or DAT deck.
If you have an audio component with a
•When you connect an audio component with a
Set “DIGITAL OUT” in “AUDIO SETUP” to “ON” and then set “DOLBY DIGITAL” to “DOLBY DIGITAL” in the setup display (page 64).
•When you connect an audio component with a
Set “DIGITAL OUT” in “AUDIO SETUP” to “ON” and then set “MPEG” to “MPEG” in the setup display (page 64).
•When you connect an audio component with a
Set “DIGITAL OUT” in “AUDIO SETUP” to “ON” and then set “DTS” to “DTS” in the setup display (page 64).
AUDIO SETUP |
|
|
| |
| AUDIO ATT: |
| OFF |
|
| AUDIO DRC: |
| STANDARD |
|
| CENTER SPEAKER EQ: | FLAT |
| |
| DOWNMIX: | DOLBY SURROUND | A | |
| DIGITAL OUT: |
| ON | |
| DOLBY DIGITAL: | DOLBY DIGITAL | B | |
| MPEG: |
| MPEG | |
| DTS: |
| DTS |
|
| 48kHz/96kHz PCM: | 48kHz/16bit | C | |
|
|
|
|
To set, press , then ENTER .
To quit, press DISPLAY .
Notes
•When you do not connect an audio component with a
•When you do not connect an audio component with a
•When you do not connect an audio component with a
•When you connect the component via the DIGITAL OUT OPTICAL or COAXIAL connector, the Virtual 3D Surround effect cannot be heard.
*Manufactured under license from Dolby Laboratories. “Dolby,” “Pro Logic” and the
Confidential unpublished works.
Started Getting
11