Camera ID

The ID can be set up to 65,536 (0000 to FFFF). As this will be memorized in the nonvolatile memory inside, data will be saved regardless of whether it has been backed up.

Effect

It consists of the following functions.

•Neg. Art: Negative/Positive Reversal

•Black White: Monochrome Image

Others

Mirror image

The video output from the camera can be reversed left and right using this function.

Freeze

This function captures an image in the field memory of the camera so that this image can be output continuously.

Because communication inside the camera is based on V cycle, the captured image is always the one 3V to 4Vs after the sending of a Command. Thus, you can not specify a time period after sending EVEN, ODD or a Command.

The Image Stabilizer Function

When the Image Stabilizer Function is ON, it helps in obtaining a stable image free of vibration caused by jarring movements. For a vibration frequency of around 10 Hz, correction is approximately 90%.

Note

Be advised that, when using systems equipped with Pan and Tilt functions, quick starts and stops are corrected for, causing a different movement from that of the normal image.

Basic Functions

Memory (Position preset)

Using the position preset function, 6 sets of camera shooting conditions can be stored and recalled.

This function allows you to achieve the desired status instantly, even without adjusting the following items each time.

•Zoom Position

•Digital Zoom On/Off

•Focus Auto/Manual

•Focus Position

•AE Mode

•Shutter control parameters

•Bright Control

•Iris control parameters

•Gain control parameters

•Exposure Compensation On/Off

•Exposure Level

•Backlight Compensation On/Off

•Slow Shutter Auto/Manual

•White Balance Mode

•R/B Gain

•Aperture

•ICR Shoot On/Off

Custom Preset

As with the positon preset function, the camera shooting conditions can be stored and recalled. The settings are recalled when the power is turned on. For setting items, refer to the “Initial Settings, Custom Preset and Backup” section on page 13.

Privacy Zone Settings

For subjects requiring special treatment due to privacy issues, designated areas of the image can be masked from view.

In this situation, an area can be masked using Privacy Zone settings. As shown in the diagram below, 12 blocks vertically and 16 horizontally, in a maximum of 6 places, can be masked.

•An example of a Command setting

Using 1 Command for a set: 81 01 04 76 00 02 01 05 02 0D 07 03 05 FF

0 1 2 3 4 5 6 7 8 9 A B C D E F

0

1A

2

3

4

5

6

7

8

9

B

A

B

10