32 GB
Preparations for Using the Network Functions

Precautions

• The software specifications of this display are
subject to change for improvements without notice.
• Screens shown by application software may differ
slightly from the illustrations shown in this manual.
• For safety, connect the port of this display only to a
network where there is no danger of excessive
voltage or voltage surges.
• The steps described in this manual are guaranteed
only for use under the following environment
conditions.
Operating system:
Microsoft Windows XP/Windows Vista/
Windows 7
Browser:
Microsoft Internet Explorer 7.0 or later
• To ensure security on the network, setting a user
name and password is recommended. For
information on how to make these settings, see the
section “Setup screen” (page35).
For security settings, refer to your network
administrator.

Setting an IP address

The display can be connected to a network with
10BASE-T/100BASE-TX LAN cable.
When connected to a LAN, the IP addresses of the
display can be set using one of the following two
methods. Consult your network administrator
regarding details about IP address selection.
• Assigning a fixed IP address to the display
Normally this method should be used.
• Automatically obtaining an IP address
If the network to which the display is connected has
a DHCP server, you can have the DHCP server
automatically assign an IP address. Note that in this
case the IP address may change every time the
display in which the display is installed is turned on.
Before setting the IP address, connect the LAN cable
to the display to establish the network. After about 30
seconds, turn on the display, and then start making the
desired settings.

Network Functions

• Microsoft and Windows are registered trademarks of Microsoft Corporation in the United States of America and/
or other countries.
• All other product names, company names, etc. mentioned in this manual are trademarks or registered trademarks
of their respective owners.