Sony GX7 Step 1: Unpacking, Step 2: Connecting the Aerial Cable, Step 3: Connecting the, Video Cords, input jack, A Connecting to a SCART (EURO AV)

Step 1: Unpacking

Check that you have the following items:

•Audio/video cord (pinplug ⋅ 3 y pinplug ⋅ 3) (1)

•Mains lead (1)

•Aerial cable (1)

•Remote commander (remote) (1)

•R6 (size AA) batteries (2)

Step 2: Connecting the Aerial Cable

Connect the aerial cable by following the steps below. Do not connect the mains lead until you reach “Step 5: Connecting the Mains Lead” (page 10).

to AERIAL IN			DVD recorder
AERIAL	LINE 1 - TV	LINE 3/DECODER
IN
			~ AC IN
			Y
	COAXIAL
	LINE 4 IN	LINE 2 OUT	CB
OUT	R-AUDIO-L VIDEO	S VIDEO R-AUDIO-L VIDEO S VIDEO
	OPTICAL
			CR
	DIGITAL OUT		COMPONENT
	PCM/DTS/MPEG/
	DOLBY DIGITAL		VIDEO OUT

AERIAL

IN

OUT

TV

to AERIAL OUT

to aerial input

Aerial cable (supplied)

: Signal flow

aDisconnect the aerial cable from your TV and connect it to AERIAL IN on the rear panel of the recorder.

bConnect AERIAL OUT of the recorder to the aerial input of your TV, using the supplied aerial cable.

Step 3: Connecting the

Video Cords

Connect this recorder to your TV monitor, projector, or AV
amplifier (receiver) using a video cord. Select one of the	Basic
your TV monitor, projector, or AV amplifier (receiver). This will
following patterns Athrough D, according to the input jack on
enable you to view pictures. Audio connections are explained in	Hookups
If you are connecting to a VCR or decoder
“Step 4: Connecting the Audio Cords” (page 7).
Connect your VCR to the LINE 3/DECODER jack on the	and
recorder (page 22).
	Settings
A Connecting to a SCART (EURO AV)
input jack
Connect using a SCART (EURO AV) cord (not supplied). Be
sure to make the connections firmly to avoid hum and noise.
Refer to the operating instructions supplied with the TV to be
connected. Also, when you set “Line1 Output” to “S Video” or
“RGB” in step 17 of Easy Setup (page 13), use a SCART
(EURO AV) cord that conforms to the selected signal.

DVD recorder

AERIAL	LINE 1 - TV	LINE 3/DECODER
IN

~ AC IN

					Y
	COAXIAL
	LINE 4 IN		LINE 2 OUT		CB
OUT	R-AUDIO-L	VIDEO S VIDEO	R-AUDIO-L	VIDEO S VIDEO
	OPTICAL
					CR
	DIGITAL OUT				COMPONENT
	PCM/DTS/MPEG/
	DOLBY DIGITAL				VIDEO OUT

TV

LINE 1 - TV

to i LINE1-TV

to SCART (EURO AV) input

SCART (EURO AV) cord (not supplied)

Notes

•When you connect the recorder to your TV via the SCART (EURO AV) jacks, the TV’s input source is set to the recorder automatically when you start playback. If necessary, press TV/DVD on the remote to return the input to the TV.

•If you connect this recorder to a TV with SMARTLINK, set “Line1 Output” to “Video.”

•For correct SMARTLINK connection, you will need a SCART (EURO AV) cord that has the full 21 pins. Refer to your TV’s instruction manual as well for this connection.

,continued

Step 1: Unpacking 5