1-2 (E) HKJ-101
1-2-1. To install HKJ-101 in J-H1
1. Remove the six M3 case stopper screws.
2. Remove the rear panel.
n
Store the removed rear panel in a safe place so as not
to lose it.
3. Insert the connector (CN601) on the DV-29 board into
the connector (CN41) on the CN-2478 board.
n
First, insert the connector (CN401) on the DV-29
board to the hole for i.LINK connector on the IF panel.
Then insert connector (CN601) to the connector on the
CN-2478 board.
4. Fix the DV-29 board to the IF panel and to the CN-
2478 board using the supplied screws (PWH2 x 5 : 2
screws, PSW2.6 x 5 : 3 screws).
n
When tightening the screws, tighten the screws PWH2
x 5 first of all screws.
Rear panel
M3 case stopper screws
M3 case stopper
screws
DV-29 board
CN-2478 board
PSW2.6 x 5 PSW2.6 x 5
PWH2 x 5
IF panel
CN601
CN41
CN401
5. Insert the CN-2478 board to the second slot from the
bottom of J-H1.
6. Strongly push the connector panel both from the right
and the left sides of the CN-2478 board so that the
connector on the CN-2478 board is securely inserted
into the connector on the MB-993 board.
7. Install the supplied rear panel for J-H1 using the six
M3 case stopper screws.
n
Tighten the screws in the state that the two dowels are
aligned with the holes (a) and (b) on the rear panel as
shown in the figure.
CN-2478 board
Hole (b)
Hole (a)
Dowel
Dowel
J-H1 rear panel
(Supplied accessory)
M3 case stopper
screws
M3 case stopper
screws
M3 case stopper
screws