Inserting batteries into the remote

Insert two R6 (size-AA) batteries in the RM-AAU006 remote commander.

Observe the correct polarity when installing batteries.

Notes

•Do not leave the remote in an extremely hot or humid place.

•Do not use a new battery with old ones.

•Do not mix alkaline batteries and other kinds of batteries.

•Do not expose the remote sensor to direct sunlight or lighting apparatuses. Doing so may cause a malfunction.

•If you do not intend to use the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

Tip

Under normal conditions, the batteries should last for about 3 months. When the remote no longer operates the receiver, replace all the batteries with new ones.

 

 

 

6: Calibrating the

 

Getting

automatically

appropriate settings

Started

(AUTO CALIBRATION)

 

This receiver is equipped with D.C.A.C.

 

(Digital Cinema Auto Calibration)

 

Technology which allows you to perform

 

automatic calibration as follows:

 

•Check the connection between each speaker and the receiver.

•Adjust the speaker level.

•Measure the distance of each speaker to your

listening position.

You can also adjust the speaker levels and balance manually. For details, see

“7: Adjusting the speaker levels and balance (TEST TONE)” (page 26).

Before you perform AutoCalibration

1

1 Connect the supplied ECM-AC2 optimizer microphone to the AUTO CAL MIC jack.2 Place the optimizer microphone at your listening position.3 Place the speakers so that the speakers are facing the optimizer microphone.

continued

23GB